reduced speed

Reduced speed is the performance loss that occurs when equipment runs below its validated ideal cycle rate during available production time - the tool is running, but not at intended throughput.

What Is Reduced speed?

• Definition: Gap between actual run rate and reference standard run rate under normal conditions.
• Typical Drivers: Mechanical wear, conservative parameter settings, handling delays, and control-loop drift.
• Measurement Basis: Compare observed cycle time against product- and recipe-specific ideal standards.
• Loss Behavior: Usually gradual and persistent rather than abrupt like failure downtime.

Why Reduced speed Matters

• Capacity Erosion: Speed losses reduce output even when availability appears healthy.
• Cost Increase: Lower throughput raises fixed-cost burden per wafer.
• Masking Risk: Slow deterioration can go unnoticed without strong rate monitoring.
• Planning Distortion: Schedules based on ideal rates become unreliable when derating persists.
• Continuous Improvement Value: Restoring speed often has rapid return on engineering effort.

How It Is Used in Practice

• Rate Baselines: Maintain updated ideal-cycle standards by product family and tool type.
• Gap Analysis: Investigate sustained speed variance by subsystem and operating condition.
• Corrective Actions: Apply servo tuning, preventive replacement, and recipe optimization.

Reduced speed is a major performance drain in mature production systems - recovering lost run rate is one of the fastest ways to improve output without added equipment.