dynamic range

Dynamic Range is the ratio between the largest and smallest measurable values — spanning from the detection limit (or quantification limit) at the low end to the saturation or non-linearity point at the high end, defining the full span of reliably measurable values.

Dynamic Range in Metrology

• Definition: $DR = \frac{Signal_{max}}{Signal_{min}} = \frac{LOL}{LOD}$ — where LOL is limit of linearity and LOD is limit of detection.
• Orders of Magnitude: Dynamic range is often expressed in decades — e.g., 6 orders of magnitude = $10^6$ range.
• ICP-MS: ~9 orders of magnitude (ppt to ppm) — exceptional dynamic range.
• CCD/CMOS Detectors: ~3-4 orders of magnitude — limited by well depth and read noise.

Why It Matters

• Single Calibration: Wide dynamic range allows measuring low and high concentrations with one calibration — no dilution needed.
• Multi-Element: In semiconductor contamination analysis, different contaminants span many orders of magnitude — wide DR essential.
• Saturation: Exceeding the dynamic range causes detector saturation or non-linearity — results above the range are unreliable.

Dynamic Range is the measurement span — the full range from the smallest to the largest reliably measurable value.